The control rod will fit between the two clevis sides. Metal Gear Flight Pack for Alula-TREK. So while I have flow the Trek and the Evo in various conditions it was in these early morning conditions that I confirmed to myself that the Trek flies faster, has a better glide ratio and from the same altitude I could generally get a slightly longer flight with the Trek over the Evo.
I found it a delightful plane and fun as a hand toss at thermal sites and even more fun at the slope in light wind. In video 2 the glide at the start is good, but it was made using a too far forward COG so at some distance away the nose is starting to drop and I had to bring it up on elevator. As it uses a KF-Airfoil the wings are easy to build.
I have been able to get it to about 10 meters, but the construction cannot withstand the presure and stress from the swing.
Using a small screwdriver I screwed the clevis screw into the other side of the clevis. R2106GF range is fine too, I have had the model a "speck" in a thermal off the slope.Your review will appear here immediately.https://www.youtube.com/watch?v=Ke69sH_gnJoFive hours airtime accumulated in just the first couple of outings says it all. I have not been disappointed.Neil organised a very quick delivery. I don’t know what the upper wind limit of the Libelle is but for higher winds the Alula is probably better.There is noticeably a bundle to know about this. To that end I picked up a couple of Lemon RX’s small receivers and I’m inclined to add a dream-flight Libelle to my new fleet where I’ll use one of those.If you own an Alula-TREK, would you leave a comment below if you’ve covered the leading edge with anything and, if so, what did you use! Yes it goes together easily but joins are not smooth/level the tiny clamps that hold the wings in place are a terrible idea. a very pleasing easy to assemble & fly model .a small piece of velcro claw on the wing tip aids launching grip. 2 x 4.3 gram digital servos; 1 x 300mAh NiMH battery; 1 Battery extension wire; Cost for Flight Pack $45.00; These are the parts that make up the optional Flight Pack for the Alula-Trek; Short batter extension wire to connect the battery to the receiver; Two 4.3 gram digital servos; Author's Note on the Flight Pack
I’d go for a receiver with end plugs if I need to build one of these again. This was quick and easy to do. Dream-Flight sells some optional steel weights (part DFAA002) and the compartment fits exactly four pieces of this steel ballast per the manual. Has completely sold me on DLG.The model arrived very quickly, regardless of potential delivery difficulties owing to the COVID19 situation.The kit goes together seamlessly and the manual deserves every bit of praise it gets.
Had the mk1 and thought it was time to replace it, and I was not disappointed.I have flown from the slope so far in winds 8 – 18 mph, using 28g ballast at the windier end.Tape secures the battery pack and nickels and the skid plate covers glidee and secures them in place as well.Necessary cookies are absolutely essential for the website to function properly. Good launches with visible tells when encountering thermals and climbing in thermals is Special Flight Performance for me.